ホーム > NCSC Level-1試験,NCSC Level-1試験問題集,NCSC Level-1日本語試験,NCSC Level-1試験難易度|ktest
迅速レーダー
会社案内
ソフト版
購入問題
品質保証
全商品
全部の認定試験
F.A.Q
NCSC Level-1試験,NCSC Level-1試験問題集,NCSC Level-1日本語試験,NCSC Level-1試験難易度|ktest
Ktest問題集はIT専門家からすべての問題と解答を確認して、正解率が98%になります。Nutanix Nutanix SE Academy 資格NCSC Level-1試験問題集は実験問題、多肢選択問題、単项の选択問題、ドラッグ アンド ドロップ問題及び穴埋め問題を提供しております。

NCSC Level-1試験問題集

人性化のサービス、よくお客様の立場から考えて、もっといいサービスを提供することはktestの信念です。 お客様がNutanix NCSC Level-1問題集を購入する前に無料でNutanix NCSC Level-1問題集のサンプルを試用することができます。Nutanix NCSC Level-1試験問題は定期的にアップデートしています。

無料で365日以内にNutanix NCSC Level-1問題集の更新版を贈ります
ktestのNutanix NCSC Level-1試験問題集を買ったことがあるのはお客様に365日以内に無料で問題集の更新版を贈ります。お客様が持ってる問題集はきっと最新版でございます。

KtestはPDF版およびソフトウェア版を提供することができます。
ktest Nutanix NCSC Level-1試験問題集のPDF版 はいつでも、携帯電話、コンピュータ、タブレットPCで勉強してもいいんです。どこ、いつでも勉強できます。

ソフト版は本格的な試験環境と同じです。受験者のために、本試験環境を適応することができます。受験の前に無料サンプルを体験して頂くことができます。

Ktestは無料でNutanix SE Academy NCSC Level-1試験問題集デモ(DEMO)を提供することができます。
Ktest試験問題集は真実の試験環境と同じです。お客様が購入する前に、無料でNCSC Level-1(Nutanix Certified Services Consultant (NCSC): Level 1)問題集のサンプルを使用してから、もっと自信を増やす。もし,弊社のNCSC Level-1問題集を使ったら、試験に不合格だったら、ktestが全額で返金できます。ご安心ください。

After imaging the nodes and creating the cluster successfully, the consultant connects the cluster to the customer network. When logging into Prism, the events dashboard is full of errors.
What is causing the issue?
A.The cluster was not stopped prior to connecting to the customer network.
B.The Cluster Virtual IP Address (VIP) was not set up during the process.
C.Foundation did not create the cluster successfully.
D.The consultant did not run Nutanix Cluster Check (NCC..
Answer : A

A consultant is preparing to add new nodes into an existing cluster. The current cluster AOS version is 5.8. The new expansion node is currently running AOS 5.9 code. The cluster must continue to run at its current AOS version.
Which method can be used to successfully add the node?
A.Upgrade the cluster to 5.9 and add the node through Prism Element.
B.Use Prism Element to Expand the cluster and select the re-image option.
C.Use the CLI and enter cluster add-node node-serial=''node_serial''.
D.Use Prism Element, which will downgrade the node by default during the node add process.
Answer : B

While trying to upgrade AOS in a cluster, a consultant receives a warning message that there are two powered-on VMs that need to be powered off for the upgrade to proceed.
What would cause this warning to be issued?
A.Upgrading a single-node cluster requires the VMs to be shut down.
B.Upgrading a two-node cluster requires the VMs to be shut down.
C.There are not enough resources left in the single-node cluster.
D.There are not enough resources left in the two-node cluster.
Answer : A

A consultant successfully completes a Foundation using a flat switch. The consultant then works with the customer to move the cluster over to their production network. After the move, the CVMs and hypervisors can no longer communicate, which prevents the cluster from starting.
Which option should be used to resolve this issue?
A.If the IPMI is in use, check that the IPMI can ping the default gateway over IPv6.
B.Make sure that the IPMI and CVM VLAN is manually tagged on the Host and CVM.
C.Verify that IPv6 Link Local and DHCP is enabled on all switch ports.
D.If using VLANs, confirm the hypervisor/CVM VLAN is set as Native on the switch ports.
Answer : D

A customer racks all nodes in the new cluster. The customer does not allow IPv6 for node discovery.
The consultant is not allowed to use the consultant's own flat switch in the customer's environment.
Which step should the consultant take to resolve this issue?
A.Bare metal image all nodes with Foundation VM.
B.Image each node individually with Foundation VM.
C.Connect to the top of rack switch and discover the nodes with IPv4.
D.Open a console to all nodes and statically assign IP addresses.
Answer : D

A consultant configures a Nutanix cluster and integrates the hosts into vCenter using VMware best practices. The customer has requested that the Nutanix cluster only have a single datastore.
Upon configuring the cluster per the customer requirements, vCenter displays an alert regarding the heartbeat datastore. The consultant adds the das.ignoreInsufficientHbDatastore value = true rule. The container can be seen from each host, but the alert remains active.
What should the consultant do to resolve this issue?
A.Turn off and then turn back on HA.
B.Make sure the DRS setting is turned on.
C.Create a second container.
D.Whitelist the vCenter IP address within Prism.
Answer : A
emailsales@Ktest.jp
support@Ktest.jp
オフィス営業時間: 9:00 – 19:00 (月曜日から金曜日まで)
mixi  tumblr  facebook